MOLD DESIGN · TOOLING · PLASTIC INJECTION MOLDINGInquiry list [email protected]+86 176 2030 0785

Aroma Diffuser Control Panel Bezels & Button Frames

Specify molded control trim around the button apertures, indicator window and visible joint with the diffuser shell.

Design concept showing a compact oatmeal-colored diffuser with an inset dark vertical three-button control panel, slightly stepped tower and refined speckled body, photograph clean centered front three-quarter
AI application illustration

Locate the bezel against the controls

Provide the fixed positions of the switches, ports and indicator source. Mark the panel datum and the clearance needed for a button to move or a plug to seat.

Set the fit around the visible perimeter

Identify where the bezel meets the shell and specify the allowed gap or height difference. Provide the finish reference and indicate where attachment features can remain hidden.

Review the indicator window as part of the assembly

If a separate light window is used, include its locating features, position and retention. Compare the intended appearance with the indicator both off and on.

Application reference

Aktobis · Aroma diffuser controls and housing diagram

Frequently asked questions

Can a new trim use the original control board?

Provide the original board, switch positions and shell interface. Review the new trim around the fixed features and check its fit with the matching parts.

Can the indicator window be a separate molded piece?

Yes, a separate window is an option. Include its fit and attachment in the drawing set so the extra interface can be reviewed.

Aroma Diffuser Base Plates & Feet → · Aroma Diffuser Housing RFQ Checklist →

Aroma Equipment Plastics

Discuss your drawing with OPINOX.

Bezel and shell files with reference datums and opening geometry

Discuss your project ↗
Ask about your project ↗