MOLD DESIGN · TOOLING · PLASTIC INJECTION MOLDINGInquiry list [email protected]+86 176 2030 0785

Aroma Diffuser Base Plates & Feet

Plan a molded underside plate around its support points, attachment features, vent openings and cable exit.

Design concept showing a complete triangular soft white diffuser with low oak-colored plastic base and a neatly exiting slim power lead visibly tucked into the molded channel at the back, three-quarter back-side view on study desk
AI application illustration

Define the support points

Mark the points that contact the intended resting surface. If the design uses separate pads, show the attachment recess and thickness in the seated position.

Review underside access

Mark vents, cable guides and connector openings. Show which paths must remain clear once the base, feet and outer housing are in place.

Connect the base to the mounting stack

Provide the screws or clips, internal mounting bosses and housing joint surfaces. Mark the tool access direction and datums that locate the base during assembly.

Application reference

MUJI · Base underside, feet and cable routing diagram

Frequently asked questions

Can the base be quoted separately from the pads?

Yes. List each part separately and provide the pad drawing or sample so its recess and assembled height can be included in the base review.

What can we review if an assembled unit rocks?

Review the seating surfaces, pad thickness and assembly sequence. Compare the sample with the specified reference surface and check for interference that stops the plate from seating.

Aroma Diffuser Control Panel Bezels & Button Frames → · Aroma Diffuser Housing RFQ Checklist →

Aroma Equipment Plastics

Discuss your drawing with OPINOX.

Underside and mating-shell drawings with revisions

Discuss your project ↗
Ask about your project ↗